Komatsu 830E Shop Manual page 47

WARNINGS AND CAUTIONS
The following pages give an explanation of the Warning, Caution, and Service Instruction plates and decals
attached to the truck. The plates and decals listed here are typical of this model, but because of customer options,
individual trucks may have plates and decals that are different from those shown here.
The plates and decals must be kept clean and legible. If any decal or plate becomes unable to be read or dam-
aged, it should be replaced with a new one.
A warning decal surrounds the key switch located to
the right of the steering column on the instrument
panel. The warning stresses the importance of read-
ing the operator's manual before operation.
A Grade/Speed plate is located on the left front post
of the operator's cab and provides the recommended
MAXIMUM speeds to be used when descending var-
ious grades with a loaded truck. Always refer to the
decal in operator's cab.
This decal in the truck may differ from the decal
shown here due to OPTIONAL truck equipment such
as: wheel motor drive train ratios, retarder grids, tire
sizes, etc.
A plate attached to the right rear corner of the cab
states the Rollover Protective Structure and Falling
Object Protective Structure meets various SAE per-
formance requirements.
! WARNING ! Do not make modifications to this
structure, or attempt to repair damage without
written approval from the Manufacturer. Unautho-
rized repairs will void certification.
A04046 Warnings and Cautions A4-1