Komatsu 830E Shop Manual page 184

9. Note in Figure 2-7 the four columns headed by
"OLDCFG", "OLDOEMCFG", "NEWOEMCFG"
and "NEWCFG." These are described as follows:
•
Files listed under "OLDCFG" are the old truck
configuration files created by the mine using the
previous software release which is displayed for
possible conversion.
•
Files listed under "OLDOEMCFG" are the old
OEM files created by Komatsu and given to the
mine to create the previous release configura-
tion files.
•
Files listed under "NEWOEMCFG" are the new
OEM files created by Komatsu and given to the
mine for the current software release version to
create the new configuration files.
•
Files listed under "NEWCFG" are the names of
the new configuration files to be created by the
Configuration Conversion Tool. The cursor is
there, blinking in front of the first file name in the
last column to indicate that the computer is
ready to edit these file names. The numbers
which precede each column heading indicate
the number of different files listed.
10. Note equal (=) signs appear at the beginning and
the end of the first file name line, and follows the
cursor up and down the list of files.
11. Using the RIGHT arrow key, move the cursor to
the right. The cursor will fall under the first letter of
the first file name in the last column. The UP,
DOWN and LEFT arrow keys are now ineffective.
12. Type in the name for the new file over the old
name. There is room for eight characters. If there
are more letters in the old name than in the new,
simply erase them using the space bar.
E2-28
FIGURE 2-7. CONFIGURATION CONVERSION SCREEN
Electrical Propulsion Components
If an error is made in naming this file, the operation can
be cancelled any time before [ENTER] is pressed by
first pressing [ESC]. This returns the cursor to its origi-
nal starting position where it can once again be moved
with the arrow keys. A note to this effect is displayed at
the bottom of the screen.
Note the asterisk (*) which appears in front of the new
name, and another asterisk appears in front of the col-
umn heading when you begin typing. This means the
file name is being changed, but the file has not yet
been created. The asterisks disappear if [ESC] is
pressed to cancel the renaming operation.
13. After the new name has been typed in, press
[ENTER]. This records the new file name. Note
the cursor moves back to its starting position at
the left of the file name asterisk.
This operation can be cancelled, even after [ENTER]
has been pressed by pressing [F6]. This resets the file
back to its original name.
14. Press [F4] to create the new file. The mine data
from the file in the first column is copied and put
into the OEM file in the third column to create the
name you entered in the fourth column. Note that
both asterisks (*) have changed to plus signs (+),
indicating the file has been created and copied to
the hard disk.
Use the DOWN arrow to move the cursor to the next
file name. Note the equal (=) signs move with the cur-
sor.
15. Use the RIGHT arrow key and move the cursor to
the right.
16. Type in the new file name.
17. Press [ENTER]. The example in Figure 2-9 shows
the new file name to be "TEST2."
2/02 E02016