Komatsu 830E Shop Manual page 672

FIGURE 2-14.
1. Capscrew & Nut
2. Mounting Screws -
Latch
17. Install the 2 screws removed in step 8. Be sure
the rubber felt insert is back in place after
installing the screws.
18. Reinstall window regulator track bracket as seen
in Figure 2-7. Be sure nylon bushings and gas-
kets are installed properly to prevent damage to
the glass.
19. Lift window glass in frame and install window
regulator roller track to bracket installed in step
18. See Figure 2-8.
20. Holding window glass as seen in Figure 2-9 (a
few inches from the top.) Install lower and upper
regulator rollers in their tracks. Start by moving
door panel (with window regulator) away from
cab just far enough to allow the rollers to enter
their tracks. Then with the rollers in the tracks
slide the panel toward the cab. Move the panel
just far enough to allow the upper regulator
roller to go into the track on the bottom of the
glass.
N2-10
3. Mounting Screw -
Outside Door Handle
4. Latch Assembly
5. Window Frame
Truck Cab
FIGURE 2-15.
21. Lift door panel, regulator and glass up to align
screw holes in the panel with holes in door
frame. Install screws that retain panel to door
frame.
22. Hook-up electrical connector for the window reg-
ulator. Install the two cap screws that hold the
door strap bracket to the door frame.
23. Align door check strap opening with holes in the
bracket and install bolt. Install the hair pin clip.
See Figure 2-6.
04/03 N02014