Option Operation; Operator Remote Operation; Nomenclature; Operation - Vectra Fitness Genisys 2761 User Manual

OPTiON OPErATiON

OPErATOr rEMOTE OPErATiON

Nomenclature

7
6
5
* bluE fOr channElS 1/2 OPEraTOr rEMOTE
OranGE fOr channElS 3/4 OPEraTOr rEMOTE
1 . Remote Storage Hook
2 . Treatment Pause button
3 . Channel 2 Increase Intensity button
4 . Channel 2 Decrease Intensity button
5 . Manual Stimulation button
6 . Channel 1 Decrease Intensity button
7 . Channel 1 Increase Intensity button
NOTE: Refer to page 16 for Symbol
definitions .

Operation

1
Operator Remote is to be used under
supervision of a physician or licensed
practitioner only .
The Operator Remote is not intended for
patient use .
2*
Install the Operator Remote as described
3
page 130 . Set up electrotherapy session
on
4
as described on
Start electrotherapy session by pressing the
Start Treatment Button .
STOP
TrEaTMEnT
buTTOn
STarT
TrEaTMEnT
buTTOn
pages 44-46 .
134
Vectra Genisys® Therapy System
Pause session by pressing the Pause Button
on the Remote being used .
Press the M Button on the remote to apply
Manual Stimulation . Release the M Button to
stop Manual Stimulation application .
Increase or decrease the intensity by pressing
the Up or Down Button on the Operator
Remote for the respective channel being
used . This can be done while Manual
Stimulation is being applied .
To Stop session, press the Stop Treatment
Button .
Verify each Operator Remote is
connected to the applicable jack for the
channels being used .