iNSTALLATiON/rEMOvAL
iNSTALLATiON- ChANNEL 3/4 ELECTrOThErAPY, NiMh BATTErY ANd LASEr MOduLE (CONTiNuEd)
Set Therapy System onto Module
Do not twist Ribbon Cable . If power is
applied to the system with misalignment
of pins or a twisted ribbon cable, the
controlling electronics in the Module will
be destroyed and possible damage to the
System's internal components could occur .
Set the Therapy System on the Module .
Make certain the Feet of the Therapy
System are resting in the Module Indents .
Secure Therapy System to Module
Carefully place the Therapy System and
Module on one side . With a #1 Phillips
Screwdriver, install the four 4 mm x 20 mm
screws .
Tighten screws until the Module does not
move on the Therapy System .
120
Vectra Genisys® Therapy System
Front Access Panel
With a #1 Phillips Screwdriver, remove the
screw retaining the existing Front Access
Panel .
Install Lanyard to the new Extended Front
Access Panel using the same screw .