Mounting Therapy System To Therapy System Cart; Therapy System Cart Assembly; Prepare Therapy System Cart; Mount Therapy System To Cart - Vectra Fitness Genisys 2761 User Manual

iNSTALLATiON/rEMOvAL

MOuNTiNg ThErAPY SYSTEM TO ThErAPY SYSTEM CArT

Therapy System Cart Assembly

Follow the "Assembling Therapy System
Cart" instructions shipped with the Cart for
proper assembly . If the instruction sheet is
not available visit the Chattanooga website,
www . c hattgroup . c om, to obtain a copy of
the instruction sheet .

Prepare Therapy System Cart

Remove all the Storage Bins from both
sides of the Therapy System Cart by pulling
each bin out and up .
rEMOvE
all bInS
Allow approximately 4 . 5 in (11 . 5 cm) of
the power cord extending through the
top of the cart for connecting to system .
If the system is equipped with an optional
NiMH Battery, Laser or Channel 3/4
Electrotherapy Module, it will be necessary
to allow 6 . 5 in (16 . 5 cm) of the Power Cord
extending through the top of the Therapy
System Cart .
4.5 In (11.5 cM)
SySTEM Only
6.5 In (16.5 cM)
SySTEM w/MODulE
132
Vectra Genisys® Therapy System

Mount Therapy System to Cart

Position the Therapy System onto the
Therapy System Cart with the rear of the
System over the Mains Power Cord .
Secure the System to the cart with the four
socket head screws in the Therapy System
Cart Top .
hanD TIGhTEn ThE SOckET
hEaD ScrEwS TO SEcurE
SySTEM TO carT
NOTE: Secure the System to the cart
by tightening the screws by hand
only . Do not use a wrench to
tighten the screws . Overtightening
may cause damage to the System
or Module housing .