Current Kdc Wedge Method - KoamTac KDC20 User Manual

Clear KDC Memory after Synchronization
The stored barcode data is cleared from the KDC memory after synchronization if this
option is selected. The KDC20 can store a total of 10,240 barcodes or 60KB (86
version)/160KB (85 version) of barcode data.
It is important to clear the KDC memory periodically to prevent Buffer Full

message which will prevent the KDC from storing additional data. Stored barcode
data can also be deleted using the Reset Memory feature on the KDC.
Automatically Synchronize after Connection
This option lets you automatically synchronize collected data to your computer
immediately when the KDC is connected to the host.
IMPORTANT: Remember to configure all options properly before selecting this

option.
Data synchronization can be done manually by clicking the synchronize icon if this

option is not selected.
Beep while Synchronization
You can enable or disable the beep tone during the synchronization process. A beep is
sounded each and every time barcode data is synchronized if this option is selected.
The KDC beeps 5 times when the synchronization process is complete.
Append data to File
KTSync would append data to the exiting file instead of creating a new file if user has
specified file name and Append data to File option is enabled.

5.3.3 Current KDC Wedge Method

The KDC can be configured in one of five Wedge/Store modes
Wedge Only - Scanned data is transmitted to the host. The KDC does not store

scanned data.
Wedge & Store - Scanned data is stored in the KDC and transmitted to the host.

Store Only - Scanned data is stored in the KDC but NOT transmitted to the host.

Save if Sent - Scanned data is stored in the KDC ONLY if transmission to the host

is successful.
Save if Not Sent - Scanned data is stored in the KDC ONLY if transmission to the

host is unsuccessful.
63
Revision 3.05.R6
Copyright ® 2014, KoamTac, Inc.
KDC User Manual