Current Kdc Wedge Method - KoamTac KDC200 User Manual

KDC is connected to the host.
IMPORTANT: Remember to configure all options properly before selecting this option.
Data synchronization can be done manually by clicking the synchronize icon if this option is not
selected.
Beep while Synchronization
You can enable or disable the beep tone during the synchronization process. A beep is sounded each
and every time barcode data is synchronized if this option is selected. The KDC beeps 5 times when the
synchronization process is complete.

Current KDC Wedge Method

The KDC can be configured in one of five Wedge/Store modes -
Wedge Only - Scanned data is transmitted to the host. The KDC does not store scanned data.
Wedge & Store - Scanned data is stored in the KDC and transmitted to the host.
Store Only - Scanned data is stored in the KDC but NOT transmitted to the host.
Wedge & Store if Sent - Scanned data is stored in the KDC ONLY if transmission to the host is
successfully.
Wedge & Store if Not Sent - Scanned data is stored in the KDC ONLY if transmission to the host is
unsuccessfully.
Enable Wedge (Handheld Scanner Mode) - This option will be checked if Wedge Only or
Wedge & Store option is selected.
Keep Scan Data in KDC - This option will be checked if Store Only or Wedge & Store option is
selected.
45
KDC200 User Manual