ViaSat MEOLink User Manual page 92

"Es/No Margin (0.25 to 2.0 dB; 0.25 default).
value to an effective Es/No value in ModCod calcs."
::= { mm1SiteEntry
mm1SiteAcmEsNoHysteresis OBJECT-TYPE
SYNTAX mm1HundredthdB (25..200)
UNITS "dBm"
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Es/No Hysteresis (0.25 to 2.0 dB; 0.5 default).
hysteresis in the ModCod selection procedure so that small fluctuations
of the Es/No value around thresholds do not cause the ModCod type to
change with each fluctuation."
::= { mm1SiteEntry
mm1SiteAcmReportEsNoOp OBJECT-TYPE
SYNTAX INTEGER { off(0), on(1) }
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Send Es/No report operational state.
Only one site can be selected.
::= { mm1SiteEntry
mm1SiteAupcOp OBJECT-TYPE
SYNTAX INTEGER { off(0), on(1) }
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Site participates in Automatic Uplink Power Control (AUPC) process
(ignored if Es/No reports are off)"
::= { mm1SiteEntry
mm1SiteAupcEsNoMargin OBJECT-TYPE
SYNTAX mm1HundredthdB (25..200)
UNITS "dBm"
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Es/No Margin (0.25 - 4.0 dB; 0.50 default).
to Es/No measurements."
::= { mm1SiteEntry 10 }
mm1SiteAupcEsNoHysteresis OBJECT-TYPE
SYNTAX mm1HundredthdB (25..200)
UNITS "dBm"
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Es/No Hysteresis (0.25 - 4.0 dB; 0.5 default).
hysteresis in the AUPC set procedure so that small fluctuations of
the Es/No value around thresholds do not cause the transmitter power
to change with each fluctuation."
::= { mm1SiteEntry 11 }
mm1WebConfigLockoutOp OBJECT-TYPE
SYNTAX INTEGER { off(0), on(1) }
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Web user configuration lockout operation.
7‐84
6 }
7 }
Default value is off."
8 }
9 }
MEOLink User Manual
Lowers measured Es/No
Used to provide
Send Es/No report to site if on.
AUPC algorithm adds this
Used to provide
Blocks web user from making
Rev 002vx
1141780,