ViaSat MEOLink User Manual page 86

mm1RxDemodAIfFreq OBJECT-TYPE
SYNTAX mm1TenthKHz (9500000..24500000)
UNITS "kHZ"
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Receive Demod A IF frequency, 950000.0 to 2450000.0 kHz, 0.1 kHz step."
::= { mm1ReceiveConfig
mm1RxDemodBIfFreq OBJECT-TYPE
SYNTAX mm1TenthKHz (9500000..24500000)
UNITS "kHZ"
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Receive Demod B IF frequency, 950000.0 to 2450000.0 kHz, 0.1 kHz step."
::= { mm1ReceiveConfig
mm1RxLNBRefOp OBJECT-TYPE
SYNTAX INTEGER { off(0), on(1) }
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Receive low noise block downconverter (LNB) reference enable (applies
to both demods)."
::= { mm1ReceiveConfig
mm1RxLNBDcPwrOp OBJECT-TYPE
SYNTAX INTEGER { off(0), on(1) }
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Receive low noise block downconverter (LNB) DC power enable (applies
to both demods)."
::= { mm1ReceiveConfig
mm1RxHandoverTimeLimit OBJECT-TYPE
SYNTAX mm1MilliSecond (0..60000)
UNITS "sec"
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Set the satellite handover time limit.
After handover is initiated, handover will occur even if the handover
demod cannot achieve sync (e.g., rain fade)."
::= { mm1ReceiveConfig
mm1QosPauseFrameOp OBJECT-TYPE
SYNTAX INTEGER { off(0), on(1) }
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Quality of Service (QoS) pause frame operation."
::= { mm1QosConfig
mm1QosPFUpperThresh OBJECT-TYPE
SYNTAX Unsigned32
UNITS "bytes"
MAX-ACCESS read-write
STATUS current
DESCRIPTION
"Quality of Service (QoS) pause frame upper threshold (bytes)."
7‐78
3 }
4 }
5 }
6 }
7 }
1 }
MEOLink User Manual
Rev 002vx
1141780,