Installing The Fork Protector - Husqvarna FE 450 2018 Owner's Manual

12.6

Installing the fork protector

12.7 Removing the fork legs
12 SERVICE WORK ON THE CHASSIS
–
Position the fork protector on the left fork leg. Mount and
tighten screws
Guideline
Remaining screws,
chassis
–
Position the brake line, wiring harness, and clamp. Mount and
tighten screws
–
Position the fork protector on the right fork leg. Mount and
V00903-11 tighten screws
Guideline
Remaining screws,
chassis
Preparatory work
–
Remove the headlight mask with the headlight. (
–
Raise the motorcycle with a lift stand. (
–
Remove the front wheel.
Main work
–
Remove screws
–
Remove the cable tie(s).
–
Remove screws
–
Allow the brake caliper and brake line to hang loosely to the
side.
S02105-10
–
Loosen screws
–
Loosen screws
K00601-10
1
.
M6 10 Nm (7.4 lbf ft)
2
.
3
.
M6 10 Nm (7.4 lbf ft)
p. 55)
( p. 101)
1
and take off the clamp.
2 and take off the brake caliper.
3
. Take out the left fork leg.
4
. Take out the right fork leg.
p. 113)
57