Husqvarna FE 450 2018 Owner's Manual page 85

12 SERVICE WORK ON THE CHASSIS
–
Check the chain sliding piece for wear.
» If the lower edge of the chain pins is in line with or below
the chain sliding piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
–
Tighten the screw of the chain sliding piece.
Guideline
Screw, chain slid-
ing piece
E00945-10
–
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
» If the light part of the chain guide is worn:
–
Change the chain guide.
400985-01
–
Check that the chain guide is firmly seated.
» If the chain guide is loose:
–
Tighten the fitting on the chain guide.
Guideline
Remaining
screws, chassis
Remaining nuts,
chassis
F00322-01
Finishing work
–
Remove the motorcycle from the lift stand. (
M8 15 Nm
(11.1 lbf ft)
M6 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
p. 55)
83