Adjusting The Basic Position Of The Foot Brake Lever - Husqvarna FE 450 2018 Owner's Manual

13.8

Adjusting the basic position of the foot brake lever

Warning
Danger of accidents The brake system fails in the event of overheating.
If there is no free travel on the foot brake lever, pressure builds up in the brake system on the rear
brake.
–
Set the free travel on the foot brake lever in accordance with the specification.
13.9 Checking the rear brake fluid level
Warning
Danger of accidents An insufficient brake fluid level will cause the brake system to fail.
If the brake fluid level drops below the specified marking or the specified value, the brake system is
leaking or the brake linings are worn down.
–
Check the brake system and do not continue riding until the problem is eliminated. (Your authorized
Husqvarna Motorcycles workshop will be glad to help.)
Warning
Danger of accidents Old brake fluid reduces the braking effect.
–
Make sure that brake fluid for the front and rear brake is changed in accordance with the service
schedule. (Your authorized Husqvarna Motorcycles workshop will be glad to help.)
–
Disconnect spring
–
4
Loosen nut
have maximum free travel.
–
To adjust the basic position of the foot brake lever individu-
ally, loosen nut
Info
The range of adjustment is limited.
–
Turn push rod
necessary, adjust the basic position of the foot brake lever.
Guideline
Free travel at foot brake
lever
–
3
Hold screw
Guideline
Nut, foot brake lever
stop
F00468-10
–
Hold push rod
Guideline
Remaining nuts,
chassis
–
Reconnect spring
13 BRAKE SYSTEM
1
.
5
and, with push rod , turn it back until you
2 3
and turn screw accordingly.
5
accordingly until you have free travel
3 ... 5 mm (0.12 ... 0.2 in)
2
and tighten nut .
M8 20 Nm (14.8 lbf ft)
5 4
and tighten nut .
M6 10 Nm (7.4 lbf ft)
1
.
A
. If
95