Installing The Lower Triple Clamp - Husqvarna FE 450 2018 Owner's Manual

12.10

Installing the lower triple clamp

3 0 0 3
2 0 0 2
1 0 0 1
12 SERVICE WORK ON THE CHASSIS
Main work
–
Open the cable holder in front of the right radiator and detach
the wiring harness.
–
Remove screws
side.
–
Open the cable holder in front of the left radiator and detach
the wiring harness.
K00602-10
–
Remove screw
–
Remove screw
–
Take off the upper triple clamp with the handlebar and set it
aside.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
S02074-10
–
Remove O-ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
F00278-10
Main work
–
Clean the bearing and sealing elements, check for damage,
and grease.
High viscosity grease (
–
Position the lower triple clamp with the steering stem. Mount
the upper steering head bearing.
–
Check whether upper steering head seal
tioned.
–
Mount protective ring
B01632-10
1
and hang the voltage regulator to the
2
.
3
.
4 5
and protective ring .
p. 153)
1
2 3
and O-ring .
is correctly posi-
59