Changing The Turn Signal Bulb - Husqvarna FE 450 2018 Owner's Manual

15.9

Changing the turn signal bulb

Note
Damage to reflector Grease on the reflector reduces the brightness.
Grease on the bulb will evaporate due to the heat and be deposited on the reflector.
–
Clean and degrease the bulbs before mounting.
–
Do not touch the bulbs with your bare hands.
–
Pull out headlight bulb
–
Insert the new headlight bulb.
Headlight (HS1 / Sockel PX43t) (
–
Insert the protection cap with the bulb socket into the reflec-
tor and turn it clockwise all the way.
–
Ensure that O-ring
–
Insert the bulb socket of the parking light into the reflector.
F00361-10
Finishing work
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
Main work
–
Remove the screw and carefully remove diffuser
–
Press the turn signal bulb
counterclockwise by about 30°, and take it out of the socket.
Info
Do not touch the reflector with your fingers and keep it
free from grease.
–
Press the new turn signal bulb carefully into the socket and
turn it clockwise until it stops.
Turn signal (RY10W / socket BAU15s) (
–
Position the diffuser.
–
Insert the screw and first turn counterclockwise until it
engages in the thread with a small jerk. Tighten the screw
lightly.
E00499-10
Finishing work
–
Check that the turn signal system is functioning properly.
15 ELECTRICAL SYSTEM
3
.
p. 147)
4
is seated properly.
p. 116)
2
carefully into the socket, turn it
p. 147)
p. 113)
1
.
115