12 SERVICE WORK ON THE CHASSIS
12.46
12.47
88
F00454-10
K00610-10
Removing the engine guard
H01655-01
Installing the engine guard
H01655-01
–
4
Fill bleeding syringe
with the appropriate hydraulic fluid.
Syringe (50329050000)
Brake fluid DOT 4 (
p. 151)
–
On the clutch slave cylinder, release bleeder screw
4
mount bleeding syringe
–
Now press the fluid into the system until it emerges from the
6
hole
of the master cylinder without bubbles.
–
Now and then, extract fluid from the master cylinder reservoir
to prevent overflow.
–
Remove the bleeding syringe. Tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below container
rim
–
Position the cover with the membrane. Mount and tighten the
screws.
Info
Clean up overflowed or spilled brake fluid immediately
with water.
–
1
Remove screws
and engine guard.
–
Attach the engine guard on the frame at the rear and swing
up at the front.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
5
.
4 mm (0.16 in)
1
.
M6
10 Nm (7.4 lbf ft)
and