Husqvarna FE 450 2018 Owner's Manual page 80

12 SERVICE WORK ON THE CHASSIS
78
–
Position the fuel tank and fit the two spoilers to the sides in
front of the radiator bracket.
–
Make sure that no cables are trapped or damaged.
F00309-11
–
Mount the fuel tank breather.
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
F00308-11
–
Position the horn with the horn bracket.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
F00307-11
–
Plug in the connector
–
Remove the wash cap set.
–
Thoroughly clean the plug-in connection of the fuel line with
an air line.
Info
Dirt should not be allowed to get into the fuel line
under any circumstances. Dirt in the fuel line clogs
the injection valve!
V00484-11
–
Lubricate the O-ring and connect plug-in connection
the fuel line.
Info
Route the cable and fuel line at a safe distance from
the exhaust system.
Finishing work
–
Mount the seat. (
–
Install the air filter box cover. (
1
with the rubber bushing.
M6 10 Nm (7.4 lbf ft)
2
with the collar bushings.
M6 10 Nm (7.4 lbf ft)
3
for the fuel pump.
p. 68)
p. 69)
4 for