Checking The Basic Position Of The Shift Lever - Husqvarna FE 450 2018 Owner's Manual

17 TUNING THE ENGINE
17.6
17.7
126
H02263-10

Checking the basic position of the shift lever

Info
When driving, the shift lever must not touch the driver's boot when in the basic position.
When the shift lever keeps touching the boot, the transmission will be subject to an excessive load.
400692-10
Adjusting the basic position of the shift lever
401950-12
Danger
Danger of poisoning Exhaust gases are toxic and
inhaling them may result in unconsciousness and
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use an effective exhaust extraction system when
starting or running the engine in an enclosed
space.
–
Allow the vehicle to idle.
The malfunction indicator lamp stops flashing once
teaching is completed.
Info
If the engine becomes too hot, perform a cool-down
ride at medium revs.
Then do not switch off the engine after this, but leave
it running at idle speed until teaching is completed.
–
Sit on the vehicle in the riding position and determine the
A
distance between the upper edge of your boot and the
shift lever.
Gap between the shift
lever and the top of the
boot
» If the distance does not meet the specifications:
–
Adjust the basic position of the shift lever.
( p. 126)
–
1
Remove screw with the washers and take off shift
2
lever .
10 ... 20 mm (0.39 ...
0.79 in)