–
Stand the vehicle upright.
–
Remove the cable ties on the frame protector.
–
Remove screw cap
S02094-10
–
Press the brake caliper onto the brake disc by hand in order
to push back the brake piston and ensure that brake fluid
does not flow out of the brake fluid reservoir, extracting it by
suction if it does.
Info
Make sure when pushing back the brake piston that
you do not press the brake caliper against the spokes.
–
Remove cotter pin
H02368-11
–
Push leaf spring
–
Remove brake linings.
–
Clean the brake caliper and brake caliper support.
–
Check that leaf spring
plate
6
in the brake caliper support are seated correctly.
H02369-10
–
Insert the new brake linings.
–
5
Mount pin
Leaf spring
Info
Always change the brake linings in pairs.
Make sure that decoupling plate
the piston side brake lining.
H02370-10
–
Mount cotter pins
–
Operate the foot brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
13 BRAKE SYSTEM
1
2
with membrane
3
.
4
downwards and remove pin
4
in the brake caliper and sliding
.
4
engages in the groove on the pin.
7
3
.
and the shim.
5
.
is mounted on
99