18 SERVICE WORK ON THE ENGINE
–
Position long oil screen
–
Position the pin wrench through the drill hole of the screw
plug in the opposite section of the engine case.
–
Push the oil screen all the way into the engine case.
F00444-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil
screen
–
Mount and tighten oil drain plug
new seal ring.
Guideline
Oil drain plug with
F00445-10
magnet
–
Remove screws
ring.
F00440-10
–
6
Pull oil filter
Lock ring plier (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surface.
F00446-10
–
Lay the motorcycle on its side and fill the oil filter housing to
about ⅓ full with engine oil.
–
Insert the new oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it together with
oil filter cover
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
F00440-11
–
Stand the motorcycle upright.
4
with the O-rings on a pin wrench.
3
with the O-ring.
M20x1.5
15 Nm (11.1 lbf ft)
1
with the magnet and a
M12x1.5
20 Nm (14.8 lbf ft)
5
. Remove the oil filter cover with the O-
out of the oil filter housing.
7
.
M6
10 Nm (7.4 lbf ft)
131