Husqvarna FE 450 2018 Owner's Manual page 84

12 SERVICE WORK ON THE CHASSIS
82
–
Pull at the top part of the chain with the specified weight
Guideline
Weight of chain wear mea-
surement
–
Measure distance
section.
Info
Chain wear is not always even, so you should repeat
this measurement at different chain positions.
Maximum distance
the longest chain section
»
If distance
–
Change the drivetrain kit.
400987-10
–
Check the chain sliding guard for wear.
» If the lower edge of the chain pins is in line with or below
the chain sliding guard:
–
Change the chain sliding guard.
–
Check that the chain sliding guard is firmly seated.
» If the chain sliding guard is loose:
–
Tighten the screws on the chain sliding guard.
Guideline
Screw, chain
sliding guard
E00944-10
10 ... 15 kg (22 ... 33 lb.)
B of 18 chain rollers in the lower chain
B 272 mm (10.71 in)
at
B
is greater than the specified measurement:
Info
When a new chain is mounted, the rear
sprocket and engine sprocket should also be
changed.
New chains wear out faster on old, worn
sprockets.
M6 14 Nm (10.3 lbf ft)
A
.
®
Loctite 243™