11.9
Adjusting the spring preload of the shock absorber
Caution
Risk of injury Parts of the shock absorber will fly off if the shock absorber is disassembled incor-
rectly.
The shock absorber is filled with highly compressed nitrogen.
–
Please follow the description provided. (Your authorized Husqvarna Motorcycles workshop will be
glad to help.)
Info
Before changing the spring preload, make a note of the present setting, e.g., by measuring the spring
length.
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the shock absorber.
–
After removing the shock absorber, clean it thoroughly.
Main work
–
Loosen screw
–
Turn adjusting ring
sion.
Holding wrench (90129051000)
–
Measure the overall spring length while the spring is not
under tension.
–
Tighten the spring by turning adjusting ring
A
ment
.
Guideline
Spring preload
Info
Depending on the static sag and/or the riding sag, it
may be necessary to increase or decrease the spring
preload.
–
Tighten screw
402659-10
Guideline
Screw, shock
absorber adjusting
ring
Finishing work
–
Install the shock absorber.
–
Check the free travel of the foot brake lever. (
–
Remove the motorcycle from the lift stand. (
11 TUNING THE CHASSIS
p. 55)
(
p. 64)
1
.
2
until the spring is no longer under ten-
14 mm (0.55 in)
1
.
M5
5 Nm (3.7 lbf ft)
(
p. 66)
2
to measure-
p. 94)
p. 55)
49