Maximum Packet Size; H.264 Payload Type; Polycom Compatibility Mode - 2N IP intercom Configuration Manual

QoS DSCP value – set the video RTP packet priority in the network. The set
value is sent in the TOS (Type of Service) field in the IP packet header.
Maximum packet size – set the size limit for the video RTP packets to be sent.
H.264 payload type (1) – set the payload type for video codec H.264
(packetisation mode 1). Set a value from the range of 96 through 127, or 0 to
disable this codec type.
H.264 payload type (2) – set the payload type for video codec H.264
(packetisation mode 2). Set a value from the range of 96 through 127, or 0 to
disable this codec type.
H.263+ payload type – set the payload type for video codec H.263+
(packetisation mode 3). Set a value from the range of 96 through 127.
Polycom compatibility mode – set SDP compatibility with some earlier Polycom
and Cisco phone models. If this mode is on, the intercom does not send the
sendonly flag in the SDP message in the video codec offer.
Tip
For the Video Preview feature at the
(video transferred via Early Media) no configuration is needed. Check
your PBX vendor whether this feature is supported by your PBX system.
For the Video Preview feature at the
transferred via jpg images) it is necessary to set
Unsecure
2N ® Indoor Touch Tab
2N TELEKOMUNIKACE a.s., www.2n.cz
and Authentication
Grandstream GXV 3275
Gigaset Maxwell 10
to None at the Camera API
phone
phone (video
Connection Type to
in HTTP API.
125/198