Induction Loop Module Configuration - 2N IP intercom Configuration Manual

Module name
SetOutput, GetInput and InputChanged objects in the
Direction – set the passage direction for the card reader (Not Specified, In, Out)
for the attendance system purposes.
Multiple authentication –
connected card reader (or the user authentication option defined in Directory /
Users ). Disable multiple authentication for a card reader to cancel code
authentication via the numeric keypad.
Associated switch
valid code is received
Received code format
26, 32, 37 and RAW).
Card read signalling – set one of the card reading signalling modes:
Full – acoustic signals distinguish valid/invalid cards
Single beep –
None – acoustic signalling is disabled.
Forward to Wiegand output
received codes will be resent
Transmitted code format
(Wiegand 26, 32, 37 and RAW).
Output Wiegand group
from the connected card readers or Wiegand inputs can be resent.

Induction Loop Module Configuration

Maximum power – set the maximum transmission power for the induction loop
antenna. A higher transmission power means a wider range, but less power for
other intercom functions. The convenient default value is 0.25 W under normal
circumstances.
2N TELEKOMUNIKACE a.s., www.2n.cz
– set the module name for input/output specification in the
enable multiple user authentication via a Wiegand-
– set the number of the switch to be activated whenever a
.
– set the format for the codes to be received (Wiegand
one beep signals both valid and invalid cards
– set the group of Wiegand outputs to which all the
.
– set the format for the codes to be transmitted
– assign the output Wiegand group to which the codes
Automation settings.
113/198