Switch Enabled; Switch Mode; Switch-On Duration; Distinguish On/Off Codes - 2N IP intercom Configuration Manual

The switch can work in the monostable or bistable mode. The switch is switched off
after a timeout in the monostable mode, and switched on with the first activation and
off with the next activation in the bistable mode.
The switch signals its state:
by a programmable beep or a predefined user sound.
by a LED indicator if available in the intercom model.
by an open-door icon on the display if available in the intercom model.
List of Parameters
Switch enabled – enable/disable the switch globally. When disabled, the switch
cannot be activated by any of the available codes (including user switch codes),
by a call or quick dial button.
Switch mode – set the monostable/bistable mode for the switch. The switch is
switched off after a timeout in the monostable mode, and switched on with the
first activation and off with the next activation in the bistable mode.
Switch-on duration – set the switch-on time for a monostable switch. This value
is not applied in the bistable mode.
Time profile – assign the switch a time profile to enable switch-on. If the time
profile is inactive, the switch cannot be activated by a code, call or quick dial
button.

Distinguish on/off codes

are used for switch activation and even codes (2, 4 ...) are for switch
deactivation. This mode can only be used if the switch is set to the bistable
mode.
"Test the switch" button
an electric lock or another device connected.
2N TELEKOMUNIKACE a.s., www.2n.cz
– set a switch code mode in which odd codes (1, 3 ....)
– activate the switch manually to test its function, e.g.
66/198