Legacy Switch Code - 2N IP intercom Configuration Manual

Tip
With an external relay,
used:
To turn on the switch –
http://192.168.1.10/state.xml?relayState=1
To turn on for pre-defined time (default value is 1.5 s) – http://ip_address
/state.xml?relayState=2
To turn off -
168.1.10/state.xml?relayState=0
With an external relay,
used (replace the X symbol with the relay number):
To turn on the switch –
http://192.168.1.10/state.xml?relay1State=1
To turn on for pre-defined time (default value is 1.5 s) – http://ip_address
/state.xml?relayXState=2
)
To turn off -
168.1.10/state.xml?relay1State=0
Legacy switch code – enable the option to activate the first-listed switch code
from the phone without being confirmed with *. When this box is checked, first
code does not require confirmation by *. This setting does not apply to other
switch codes listed and to numeric keypad code activation, those must be
always confirmed by *. The Legacy switch code helps you keep back
compatibility with earlier 2N intercom models.
Note
The switch time profiles are available with the Gold or Enhanced
Integration licence only.
2N TELEKOMUNIKACE a.s., www.2n.cz
Part No. 9137410E
http://ip_address/state.xml?relayState=1
(e.g.: http://192.168.1.10/state.xml?relayState=2
http://ip_address/state.xml?relayState=0
)
Part No. 9137411E
http://ip_address/state.xml?relayXState=1
(e.g.: http://192.168.1.10/state.xml?relay1State=2
http://ip_address/state.xml?relayXState=0
)
, the following HTTP commands are
)
, the following HTTP commands are
)
(e.g.:
)
(e.g.: http://192.
(e.g.:
(e.g.: http://192.
71/198