Remote Packet Capture; Maintenance - 2N Clip User Manual

Local Packet Capture
We recommend that you lower the video stream transmission rate below 512 kbps while
capturing packets locally. When the local capture buffer is full, the oldest packets are
rewritten automatically.

Remote Packet Capture

Syslog
Syslog Server Settings
Send Syslog Messages – enable sending of syslog messages to the Syslog server. Make sure
that the server address is valid.
Server Address – IP/MAC address of ther server on which the syslog recording application is
running.
Level of Sent Messages – set the detail level for the messages to be sent (Error, Warning,
Notice, Info, Debug 1–3). Debug 1–3 level setting is only recommended to facilitate
troubleshooting for the Technical Support department.
Local Syslog Messages
This block provides a general overview of local Syslog messages. Local Syslog messages can
be uploaded and downloaded

5.2.8.7 Maintenance

This menu helps you maintain the device configuration and firmware. You can back up and
restore all the parameters, upgrade firmware and/or factory reset the device.
Configuration
Restore Configuration – restore configuration from a previous backup. Press the button to
display a dialogue window to select a configuration file and upload it to the device. Before
1. Click the icon
2. Click the icon
3. Click to save the packet capture file on a disk.
1. Click .
2. A box will open for you to set the incoming/outgoing packet capturing
time (in seconds).
3. Click OK to start capture.
4. Select a location on the disk for the packet capture file to be saved.
5. Click to stop capturing.
to start packet capturing.
to stop packet capturing.
.
2N® Clip User Manual
50 / 75