Image Stabilization Timeout (Sense Mode) - Newland NLS-HR32-BT User Manual

Enter Setup

Image Stabilization Timeout (Sense Mode)

This parameter defines the amount of time the scanner will spend adapting to ambient environment after it decodes a
barcode and "looks" for another. It is programmable in 1ms increments from 0ms to 3,000ms. The default setting is 200ms.
Set the image stabilization timeout to 800ms:
1. Scan the Enter Setup barcode.
2. Scan the Image
3. Scan the numeric barcodes "8", "0" and "0" from the "Digit Barcodes" section in Appendix.
4. Scan the Save barcode from the "Save/Cancel Barcodes" section in Appendix.
5. Scan the Exit Setup barcode.
** Exit Setup
Image Stabilization Timeout
Stabilization Timeout barcode.
32