Sense Mode - Newland NLS-HR11 User Manual

** Enter Setup

Sense Mode

Sense Mode: The scanner activates a decode session every time when it detects a change in ambient
illumination and meets the requirement of the image stabilization timeout. Decode session continues until
barcode is decoded or the decode session timeout expires. A trigger pull can also activate a decode
session. By default, the scanner rereads same barcode with no delay.
Decode Session Timeout: This parameter sets the maximum time decode session continues during a
scan attempt. It is programmable in 1s increments from 1s to 255s. The default timeout is 15s. If the
parameter is set to 0, the decode session timeout is infinite.
Example: Set the decode session timeout to 5s
1. Scan the Enter Setup barcode.
2. Scan the Decode Session Timeout barcode.
Scan the numeric barcode "5". (See the Digit Barcodes section in Appendix)
3.
4. Scan the Save barcode. (See the Save/Cancel Barcodes section in Appendix)
5. Scan the Exit Setup barcode.
Exit Setup
Sense Mode
Decode Session Timeout
50