Dahua HCVR5104C User Manual page 600

Parameter Function
There are two types: local/remote. Please select local mode if you are
PTZ type
connect RS485 cable to connect to the Speed dome (PTZ). Please
select remote mode if you are connecting to the network PTZ camera.
You can select control mode from the dropdown list. There are two
Control
mode
options: Serial/HDCVI. For HDCVI series product, please select
HDCVI. The control signal is sent to the PTZ via the coaxial cable. For
the serial mode, the control signal is sent to the PTZ via the RS485
port.
Please select protocol from the dropdown list.
Protocol
If the control mode is HDCVI, please select HDCVI protocol. The
default setup is HDCVI3.0.
Set corresponding dome address. Default value is 1. Please note
Address
your setup here shall comply with your dome address; otherwise
you cannot control the speed dome.
Select the dome baud rate. Default setup is 9600.
Baud Rate
Data Bit Default setup is 8. Please set according to the speed dome dial switch
setup.
Default setup is 1. Please set according to the speed dome dial switch
Stop bit
setup.
Parity Default setup is none. Please set according to the speed dome dial
switch setup.
5.10.5.6 Alarm box
It is to view the connected alarm box state. See Figure 5- 126.
5.10.5.7 ATM/POS
The ATM/POS function is for financial areas. It includes Sniffer, information analysis and
title overlay function. The Sniffer mode includes COM and network.
5.10.5.7.1 COM Type
The COM interface is shown as below. See Figure 5- 127.
Protocol: Please select from the dropdown list according to your actual situation.

Overlay channel: Please select the channel you want to overlay the card number.

Figure 5- 126
584