Table of Contents
Advertisement
Note
Click Add more to add more holidays if necessary.
Step 4
Click Add button.
Device goes back to Figure 4- 16 to display the new holiday.
Note
The new holiday state is on by default. Select from the dropdown list to
disable.
Drag the slide bar, click
Note
After successfully set holiday here, you can view holiday item in Schedule interface. It
is for you to set holiday schedule record/snapshot settings.
4.1.4.2 Network
Before the operation, make sure the device has properly connected the network cable.
Besides startup wizard and configuration wizard, from main
menu->Setting->Network->TCP/IP, you can also go to the network interface.
Step 1
From main menu->Setting->Network->TCP/IP.
Enter TCP/IP interface. See Figure 4- 18.
Step 2
Set parameters.
Network Mode: Includes multiple access, fault tolerance, and load balancing. Please
note the network mode is not for product of single-Ethernet card.
Multiple-address mode: eth0 and eth1 operate separately. You can use the
services such as HTTP, RTP service via etho0 or the eth1. Usually you need to
set one default card (default setup is etho) to request the auto network service
form the device-end such as DHCP, email, FTP and etc. In multiple-address
mode, system network status is shown as offline once one card is offline.
Network fault-tolerance: In this mode, device uses bond0 to communicate with
the external devices. You can focus on one host IP address. At the same time,
you need to set one master card. Usually there is only one running card (master
card).System can enable alternate card when the master card is malfunction. The
system is shown as offline once these two cards are both offline. Please note
these two cards shall be in the same LAN.
Load balance: In this mode, device uses bond0 to communicate with the external
device. The eth0 and eth1 are both working now and bearing the network load.
Their network load are general the same. The system is shown as offline once
these two cards are both offline. Please note these two cards shall be in the same
LAN.
Default Network Card: Please select eth0/eth1/bond0(optional) after enable
multiple-access function
Main Network Card: Please select eth0/eth1 (optional).after enable multiple
to edit holiday, click
to delete holiday.
306
Advertisement
Table of Contents
