Select one monitor channel video and then click Image button in section 8, the interface is
shown as Figure 5- 19.
5.8.1 Image
Here you can adjust its brightness, contrast, hue and saturation. (Current channel border
becomes green).
Or you can click Reset button to restore system default setup.
5.8.2 Relay output
Here you can enable or disable the alarm signal of the corresponding port. See Figure
5- 20.
5.9 WAN Login
In WAN mode, after you logged in, the interface is shown as below. See Figure 5- 21.
Figure 5- 19
Figure 5- 20
502