Table of Contents
Advertisement
Step 2
Set parameters.
Enable: Check the box to enable SNMP function.
Version: Check the box and then select version. DVR can process the corresponding
version information.
SNMP port: The agent applications listening port on the DVR.
Read/write community: The read/write community string the agent applications
supports.
Trap address: The Trap information destination address of the agent applications on
the DVR.
Trap port: The Trap information destination port of the agent applications on the DVR.
Step 3
In Figure 5- 99, check the box to enable the SNMP function. Input the IP address
of the PC than is running the software in the Trap address. You can use default
setup for the rest items.
Step 4
Compile the above mentioned two MIB file via the software MIB Builder.
Step 5
Run MG-SOFT MIB Browser to load the file from the previous step to the
software.
Step 6
Input the device IP you want to manage in the MG-SOFT MIB Browser. Please
set the corresponding version for your future reference.
Step 7
Open the tree list on the MG-SOFT MIB Browser; you can get the device
configuration. Here you can see the device has how many video channels, audio
channels, application version and etc.
4.9.2.11Multicast
When you are accessing the device and view the video, the error occurs if the connected
device amount has reached the threshold. In this situation, please set multicast IP to use
multicast protocol to access.
Multicast setup interface is shown as in Figure 4- 130.
400
Advertisement
Table of Contents
