Table of Contents
Advertisement
Step 4
Set filter object. Once the object is smaller than the min size or larger than the
max size, there is no alarm.
1.
After draw the rule, set max size and min size.
2.
Click Draw target to draw the rectangle zone.
Note
Each rule can set two sizes (min size/max size). Please make sure the max
size is larger than the min size.
The default max size is the full screen, you can select the blue line and then
use mouse to adjust.
Step 5
Set parameters.
Parameter
Lasting Period
Period
Step 6
Click Save to complete setup.
5.10.3.3 Alarm
Before operation, please make sure you have properly connected alarm devices such
as buzzer. The input mode includes local alarm and network alarm.
5.10.3.3.1 Local Alarm
The local alarm interface is shown as in Figure 5- 86. It refers to alarm from the local
Figure 5- 85
Function
It refers to the time that object is staying in the zone time.
Set tripwire valid period. System generates an alarm during the
specified period. For detailed setups, please refer to chapter
5.10.3.1.1 motion detect
556
Advertisement
Table of Contents
