Table of Contents
Advertisement
Upon deactivation, the cruise control
light will go out in the tachometer but
the SET indicator and set speed will still
be
shown
in
indicating that the cruise control set
speed has been stored.
The cruise control set speed can be
resumed as described on page 107,
provided the cruise control has not
been deactivated by turning the ignition
switch to the OFF position.
Resuming the Cruise Control Set
Speed
Warning
When resuming cruise control, always
make sure that the traffic conditions
are suitable for the set speed.
Using cruise control in heavy traffic, on
roads with sharp/blind bends or when
they are slippery, may result in loss of
motorcycle control and an accident.
Cruise control will be deactivated if one
of the following actions has been taken:
• Roll the throttle twist grip fully
forward.
• Pull the clutch lever.
• Operate the front or rear brake.
• Increase
speed
throttle
grip
60 seconds.
The cruise control set speed can be
resumed by pressing and releasing the
RES/+ button provided a set speed has
been stored.
The motorcycle must be traveling at a
speed between 19 to 100 mph (30 to
160 km/h) and be in 3
the
display
screen,
by
using
for
more
gear or higher.
rd
General Information
A stored set speed is indicated by the
word SET next to the cruise control
symbol in the display screen.
The stored set speed will remain in the
cruise control memory until the ignition
switch has been turned to the OFF
position.
Note:
•
The cruise control set speed display
will flash until the resumed set
speed has been achieved.
the
than
107
Advertisement
Table of Contents
