Table of Contents
Advertisement
Warning
If the Traction Control (TC) system is
not functioning, care must be taken
when accelerating and cornering on
wet/slippery road surfaces to avoid
rear wheel spin.
In the event of a fault, the TC disabled
warning light may be accompanied by
the
engine
management
malfunction indicator light and/or the
ABS warning light.
Do not continue to ride for longer than
is necessary with any of the above
warning lights illuminated. Contact an
authorized Triumph dealer as soon as
possible to have the fault checked and
rectified.
Hard acceleration and cornering in this
situation may cause the rear wheel to
spin resulting in loss of motorcycle
control and an accident.
Cruise Control Light
The cruise control can only be
activated
when
traveling
at
19 to 100 mph (30 to 160 km/h) and is in
3
gear or higher. When activated, the
rd
cruise control light in the tachometer
will be illuminated (see page 104).
system
the
motorcycle
a
speed
between
Cruise control must only be used
where you can ride safely at a steady
speed.
Cruise control should not be used
when riding in heavy traffic, on roads
with sharp/blind bends or when they
are slippery.
Using cruise control in heavy traffic, on
roads with sharp/blind bends or when
they are slippery, may result in loss of
motorcycle control and an accident.
Turn Signals
When the turn signal switch is
turned to the left or right, the indicator
warning light will flash on and off at the
same speed as the turn signals.
High Beam Switch
When the ignition is switched
is
ON and the headlight dimmer switch is
set to HIGH BEAM, the high beam
warning light will illuminate.
Fog Lights (if equipped)
When the ignition is switched on
and the fog lights are switched on, the
fog lights warning light will illuminate.
Instruments
Warning
63
Advertisement
Table of Contents
