Table of Contents
Advertisement
Instruments
The selected mode is activated once the
following conditions for switching modes
have been met:
Motorcycle Stationary - Engine Off
• The ignition is switched ON
• The engine stop switch is in the
RUN position.
Motorcycle Stationary - Engine Running
• Neutral gear is selected or the
clutch is pulled in.
Motorcycle in Motion
Within 30 seconds of selecting a riding
mode the rider must carry out the
following simultaneously:
• Close the throttle
• Pull the clutch in
• Make sure that the brakes are not
engaged (allow the motorcycle to
coast).
Note:
•
It is not possible to switch into or
out of OFF_ROAD or RIDER modes
while the motorcycle is in motion, if
the ABS or TC settings are set to
OFF-ROAD or OFF in either of those
modes.
•
In this case, the motorcycle must
be brought to a stop before the
riding mode change can take place.
If
a
riding
mode
completed,
the
between the previous riding mode and
the newly selected riding mode until the
change is complete or it is canceled.
The riding mode selection is now
complete and normal riding can be
resumed.
36
change
is
icon
will
alternate
Information Tray
When the motorcycle is in motion, only
attempt
information tray modes or reset the
fuel information under the following
conditions:
• At low speed
• In traffic free areas
• On
straight
surfaces
• In good road and weather conditions.
Failure
to
warning
motorcycle control and an accident.
The information tray appears at the
bottom of the display screen and allows
easy access to different motorcycle
status information.
2
not
1.
Joystick control
2.
Information tray
To view the different information tray
items, push the joystick left/right until
the required information tray item is
shown.
Warning
to
switch
between
and
level
observe
this
could
lead
to
F
07:29
AM
17.5
o
mph
1
E
59
42
MPG
MPG
RANGE
the
roads
or
important
loss
of
12 14
RPM
10
x1000
N
8
6
4
12
2 0
Advertisement
Table of Contents
