Table of Contents
Advertisement
GENERAL INFORMATION
70
Deactivating Cruise Control
The cruise control can be deactivated
by one of the following methods:
▼ Roll the throttle twist grip fully
forward.
▼ Pull the clutch lever.
▼ Operate the front or rear brake.
▼ Increase speed by using the throttle
for more than 60 seconds.
Upon deactivation, the cruise control
light will go out in the tachometer but
the SET indicator and set speed will
still be shown in the display screen,
indicating that the cruise control set
speed has been stored.
The cruise control set speed can be
resumed
as
provided the cruise control has not
been deactivated by turning the ignition
switch to the OFF position.
Resuming the Cruise Control Set
Speed
When resuming cruise control, always
make sure that the traffic conditions
are suitable for the set speed.
Using cruise control in heavy traffic,
on roads with sharp/blind bends or
when they are slippery, may result
in loss of motorcycle control and an
accident.
described
on
page 70,
Warning
Cruise control will be deactivated if one
of the following actions has been taken:
▼ Roll the throttle twist grip fully
forward.
▼ Pull the clutch lever.
▼ Operate the front or rear brake.
▼ Increase speed by using the throttle
grip for more than 60 seconds.
The cruise control set speed can be
resumed by pressing and releasing the
RES/+ button provided a set speed has
been stored.
The motorcycle must be traveling at
a speed between 29 to 100 mph (46 to
160 km/h) and be in 3
A stored set speed is indicated by the
word SET next to the cruise control
symbol in the display screen.
The stored set speed will remain in the
cruise control memory until the ignition
switch has been turned to the OFF
position.
The cruise control set speed display will
flash until the resumed set speed has
been achieved.
gear or higher.
rd
Advertisement
Chapters
Table of Contents
