Deactivating Cruise Control; Resuming The Cruise Control Set Speed - Triumph Tiger XCA Owner's Handbook Manual

General Information

Deactivating Cruise Control

The cruise control can be deactivated
by one of the following methods:
• Roll the throttle twist grip fully
forward.
• Pull the clutch lever.
• Operate the front or rear brake.
• Increase speed
throttle for more than 60 seconds.
Upon deactivation, the cruise control
light will go out in the tachometer but
the SET indicator and set speed will still
be shown in
indicating that the cruise control set
speed has been stored.
The cruise control set speed can be
resumed as described
provided the cruise control has not
been deactivated by turning the ignition
switch to the OFF position.
Resuming the Cruise Control Set
Speed
Warning
When resuming cruise control, always
make sure that the traffic conditions
are suitable for the set speed.
Using cruise control in heavy traffic, on
roads with sharp/blind bends or when
they are slippery, may result in loss of
motorcycle control and an accident.
92
by using
the display screen,
page 92,
on
Cruise control will be deactivated if one
of the following actions has been taken:
• Roll the throttle twist grip fully
forward.
• Pull the clutch lever.
• Operate the front or rear brake.
• Increase
throttle
the
60 seconds.
The cruise control set speed can be
resumed by pressing and releasing the
RES/+ button provided a set speed has
been stored.
The motorcycle must be traveling at a
speed between 19 to 100 mph (30 to
160 km/h) and be in 3
A stored set speed is indicated by the
word SET next to the cruise control
symbol in the display screen.
The stored set speed will remain in the
cruise control memory until the ignition
switch has been turned to the OFF
position.
Note:
• The cruise control set speed display
will flash until the resumed set
speed has been achieved.
speed by using
grip for more
gear or higher.
rd
the
than