Table of Contents
Advertisement
If the DRL switch is in the daytime
running lights position, then press and
hold the high beam button to turn the
high beam on. It will remain on as long
as the button is held in and will turn off
as soon as the button is released.
Note:
•
A lighting on/off switch is not
installed on this model. The brake/
tail light and license plate light all
function automatically when the
ignition is turned to the ON position.
•
The headlight will function when
the ignition switch is turned to the
ON position. The headlight will go
off
while
pressing
button until the engine starts.
Daytime Running Lights (DRL)
When the ignition is switched
ON and the daytime running lights
switch is set to DAYTIME RUNNING
LIGHTS, the daytime running lights
warning light will illuminate.
The daytime running lights and low
beam headlights are operated manually
using a switch on the left hand switch
housing, see page 97.
the
starter
Note:
•
•
Low Fuel Warning Light
illuminate when there is approximately
1.0 gallon (3.5 liters) of fuel remaining in
the tank.
Warning
Do not ride for longer than necessary
in poor ambient light conditions with
the Daytime Running Lights (DRL) in
use.
Riding
with
the
Lights when dark, in tunnels or where
poor ambient light is apparent may
reduce the riders vision or blind other
road users.
Blinding other road users or reduced
vision in low ambient light levels may
result in loss of motorcycle control and
an accident.
During daylight hours the Daytime
Running
Lights
motorcycles visibility to other road
users.
Low beam headlights must be used
in any other conditions unless the
road conditions allow for high beam
headlights to be used.
The low fuel warning light will
Instruments
Daytime
Running
improve
the
29
Advertisement
Table of Contents
