Table of Contents
Advertisement
There are three levels of heat: low,
medium and high. This is indicated by
the different colors of the symbols
shown in the display.
1
1.
Low heat symbol (yellow)
2.
Medium heat symbol (orange)
3.
High heat symbol (red)
For maximum benefit in cold conditions,
from the OFF position press the switch
once for the high heat setting initially
and then reduce the heat level by
pressing the switch again for a low heat
setting when the grips have warmed up.
To turn off the heated grips, press and
release the switch until the heated grips
symbol is no longer shown in the
display.
Low Power Voltage Cut Off
If a low voltage is detected, the heated
grips switch will power off. The heated
grips will not function again until the
voltage rises to a safe level.
The switch will not power back on
automatically even if the voltage rises to
the safe level. The user must manually
press the switch again to activate the
heated grips.
Fog Lights Switch (if equipped)
To turn the fog lights on or off, with the
headlights on, press and release the fog
lights switch. When the fog lights are
turned on, the fog lights indicator will
illuminate in the display.
2
3
General Information
Note:
•
The fog lights switch will only
operate when the headlights are on.
•
The fog lights switch will reset to
off when the ignition is turned off
then on again.
High Beam Button
The high beam button has a different
function depending on whether Daytime
Running Lights (DRL) are installed or
not. When the high beam is turned on,
the high beam indicator light will
illuminate in the display.
Models with Daytime Running
Lights (DRL)
If the DRL switch is in the Daytime
Running Lights (DRL) position, then
press and hold the high beam button to
turn the high beam on. It will remain on
as long as the button is held in and will
turn off as soon as the button is
released.
If the DRL switch is in the dip beam
position, press the high beam button to
switch the high beam on. Each press of
the button will swap between dip and
high beam.
Note:
•
A lighting on/off switch is not
installed on this model. The brake/
tail light and license plate light all
function automatically when the
ignition is turned to the ON position.
•
The headlight will function when
the ignition is turned on and the
engine is running.
99
Advertisement
Table of Contents
