Table of Contents
Advertisement
Note:
•
TC
and
optimized
(if equipped) may not function if
there is a malfunction with the ABS
system.
In
warning lights for the ABS, TC and
the MIL may be illuminated.
For full details of the TC disabled
warning
light
associated
instrument
messages, see page 27.
Traction Control Settings
Warning
If the traction control is disabled, the
motorcycle will handle as normal but
without traction control.
In this situation accelerating too hard
on wet/slippery road surfaces may
cause the rear wheel to slip, and may
result in loss of motorcycle control and
an accident.
The TC system can be disabled as
described in Bike Setup on page 48, or
set to the conditions described in Riding
Mode Configuration on page 44.
TC
control
this
situation,
operation
and
warning
General Information
Tire Pressure Monitoring
System (TPMS) (if equipped)
the
its
The daily check of tire pressures must
not be excluded because of the
installation of the TPMS. Check the tire
pressure when the tires are cold and
using an accurate tire pressure gage
(see page 189).
Use of the TPMS system to set
inflation
incorrect tire pressures leading to loss
of motorcycle control and an accident.
Function
Tire pressure sensors are mounted to
the front and rear wheels. These
sensors measure the air pressure inside
the tire and transmit pressure data to
the instruments. The sensors will not
transmit data until the motorcycle
reaches
12 mph (20 km/h). Two dashes will be
visible in the system display until the
tire pressure signal is received.
After bring the motorcycle to a stop, the
sensors continue to transmit data for
approximately seven minutes before
switching off. The tire pressure values
remain visible in the system display until
the sensors switch off.
An adhesive label will be mounted to the
wheel rim to indicate the position of the
tire pressure sensor, which is near the
valve.
Warning
pressures
may
a
speed
of
approximately
lead
to
111
Advertisement
Table of Contents
