Resuming The Cruise Control Set Speed; Traction Control (Tc) - Triumph Street Triple R Owner's Handbook Manual

GENERAL INFORMATION
106
Resuming the Cruise Control Set
Speed
When resuming cruise control, always
make sure that the traffic conditions
are suitable for the set speed.
Using cruise control in heavy traffic,
on roads with sharp/blind bends or
when they are slippery, may result
in loss of motorcycle control and an
accident.
Cruise control will be deactivated if one
of the following actions has been taken:
Roll the throttle twist grip fully
▼
forward.
Pull the clutch lever.
▼
Operate the front or rear brake.
▼
Increase speed by using the throttle
▼
grip for more than 60 seconds.
The cruise control set speed can be
resumed by pressing and releasing the
RES/+ button provided a set speed has
been stored.
The motorcycle must be traveling at
a speed between 19 to 100 mph (30 to
160 km/h) and be in 3
A stored set speed is indicated by the
word SET next to the cruise control
symbol in the display screen.
The stored set speed will remain in the
cruise control memory until the ignition
switch has been turned to the OFF
position.
Note
The cruise control set speed display will
flash until the resumed set speed has
been achieved.
Warning
gear or higher.
rd

Traction Control (TC)

Warning
The traction control and optimized
cornering traction control systems
are not a substitute
appropriately for
surface and weather
The systems cannot prevent loss of
traction due to; excessive speed when
entering turns, accelerating at a sharp
lean angle and braking.
Traction control or optimized cornering
traction control cannot prevent the
front wheel from slipping.
Failure to observe any of the above
may result in loss of motorcycle
control and an accident.
Traction control
traction when accelerating on wet/
slippery road surfaces. If sensors detect
that the rear wheel is losing traction
(slipping), the traction control system
will engage and alter the engine power
until traction to the rear wheel has been
restored. The traction control warning
light will flash while it is engaged and
the rider may notice a change to the
sound of the engine.
Traction control will not function if
there is a malfunction with the ABS.
The warning lights for the ABS, traction
control and the MIL will be illuminated.
for riding
the prevailing
conditions.
helps to maintain