Table of Contents
Advertisement
Battery Installation
Warning
Make sure that the battery terminals
do not touch the motorcycle frame as
this may cause a short circuit or spark,
which would ignite battery gases
causing a risk of personal injury.
To install the battery:
• Place the battery in the battery
case.
• Reconnect the battery, positive
(red) lead first.
• Apply a light coat of grease to the
terminals to prevent corrosion.
• Cover the positive terminal with the
protective cap.
• Re-install the battery strap.
• Reinstall the chassis ECM cover and
secure with the wing nut. Tighten
the wing nut to 11 lbf in (1.25 Nm).
• Reinstall the rider's seat.
Note:
•
After reconnecting the battery, it is
necessary
to
system (if equipped) to recalibrate,
see page 108.
allow
the
TSAS
Fuse Boxes
Warning
Always replace blown fuses with new
ones of the correct rating (as specified
on the fuse box cover) and never use a
fuse of higher rating.
Use of an incorrect fuse could lead to
an electrical problem, resulting in
motorcycle damage, loss of motorcycle
control and an accident.
Main Fuse
The 40 Amp main fuse is located
beneath the rider's seat and behind the
seat bridge.
To access the main fuse, the rider's seat
must be removed.
1
1.
Main fuse
Maintenance
197
Advertisement
Table of Contents
