Table of Contents
Advertisement
ABS (Anti-Lock Brake System)
Warning Light
When the ignition switch is
turned to the ON position, it is normal
that the ABS warning light will flash on
and off. The light will continue to flash
after
engine
motorcycle
first
exceeding 6 mph (10 km/h) when it will
go off.
The warning light should not illuminate
again until the engine is restarted
unless there is a fault, or:
• ABS is disabled by the rider - the
warning light will remain illuminated
(see Bike Setup on page 76 or
Riding
Mode
page 85).
• ABS is set to Off-Road – the
warning light will flash slowly (see
Riding
Mode
page 85).
Note:
•
Traction control and cruise control
may not function if there is a
malfunction with the ABS system.
In this situation, the warning lights
for the ABS, traction control and
the MIL may be illuminated.
If the warning light becomes illuminated
at any other time while riding it
indicates
that
malfunction that requires investigation.
The following warning message may be
displayed:
• WARNING - ABS SYSTEM DISABLED
The braking system will be affected as
follows:
start-up
until
reaches
a
speed
Configuration
Configuration
the
ABS
has
WARNING - ABS SYSTEM DISABLED
2
OFF-ROAD
CHECK MANUAL
the
1.
ABS warning light
2.
Instrument message
The message WARNING - ABS SYSTEM
DISABLED indicates that the ABS is not
functioning.
on
If the ABS is not functioning or has
on
been disabled by the rider (see Bike
Setup on page 76 or Riding Mode
Configuration on page 85), the brake
system will continue to function as a
non-ABS braking system.
Do not continue to ride for longer than
is necessary with the warning light
illuminated. In the event of a fault,
contact an authorized Triumph dealer
as soon as possible to have the fault
checked and rectified.
In this situation, braking too hard will
a
cause the wheels to lock resulting in
loss of motorcycle control and an
accident.
See also Braking on page 146.
Instruments
1
WARNING
ABS SYSTEM
DISABLED
PRESS SELECT
TO CLEAR
Warning
61
Advertisement
Table of Contents
