Table of Contents
Advertisement
General Information
To adjust the handlebars:
• Loosen and remove the handlebar
rear (0.31 in (8 mm) threaded) clamp
bolts, and then the front (0.39 in
(10 mm) threaded) clamp and riser
bolts.
2
chiv_3
1.
0.39 in (10 mm) bolts
2.
0.31 in (8 mm) bolts
• Lift the handlebars out of the
handlebar risers and support with
the aid of an assistant.
• Rotate both risers through 180°
and align the bolt holes.
• Reposition the handlebars to the
risers.
1
3
chiu_2
1.
Upper clamp, left hand
2.
Clamp split line, front
3.
Handlebar alignment mark
120
• Reinstall the upper clamps, and
• Rotate the handlebar so that the
1
• Tighten the 0.39 in (10 mm) bolts to
• Reinstall the 0.31 in (8 mm) bolts to
2
secure with the two 0.39 in (10 mm)
threaded bolts in the rear bolt
positions. Do not fully tighten the
bolts at this stage.
alignment
marking
handlebar aligns with the front left
hand split line of the clamp riser.
26 lbf ft (35 Nm).
the front positions and tighten to
19 lbf ft (26 Nm).
on
the
Advertisement
Table of Contents
