Table of Contents
Advertisement
Resuming the Cruise Control Set
Speed
Warning
When resuming cruise control, always
make sure that the traffic conditions
are suitable for the set speed.
Using cruise control in heavy traffic,
on roads with sharp/blind bends or
when they are slippery, may result
in loss of motorcycle control and an
accident.
Cruise control will be deactivated if one
of the following actions has been taken:
Roll the throttle twist grip fully
▼
forward.
Pull the clutch lever.
▼
Operate the front or rear brake.
▼
Increase speed by using the throttle
▼
grip for more than 60 seconds.
The cruise control set speed can be
resumed by pressing and releasing the
RES/+ button provided a set speed has
been stored.
The motorcycle must be travelling at
a speed between 29 to 100 mph (46 to
160 km/h) and be in 3
A stored set speed is indicated by the
word SET next to the cruise control
symbol in the display screen.
The stored set speed will remain in the
cruise control memory until the ignition
switch has been turned to the OFF
position.
The cruise control set speed display will
flash until the resumed set speed has
been achieved.
gear or higher.
rd
GENERAL INFORMATION
Traction Control (TC)
Warning
The traction control and optimised
cornering traction control systems
are
not
a
substitute
appropriately
for
surface
and
weather
The systems cannot prevent loss of
traction due to:
- excessive speed when entering turns
- accelerating at a sharp lean angle
- braking.
Traction control or optimised cornering
traction control cannot prevent the
front wheel from slipping.
Failure to observe any of the above
may result in loss of motorcycle
control and an accident.
Warning
After riding off-road with traction
control disabled, always make sure
that the traction control is enabled
when returning to ride on public roads.
Riding on public roads with the
traction
control
accelerating too hard on wet/slippery
road surfaces, cause the rear wheel
to slip resulting in loss of motorcycle
control and an accident.
Traction control is a system that helps
to maintain traction when accelerating
on
wet/slippery
sensors detect that the rear wheel is
losing traction (slipping), the traction
control system will engage and alter the
engine power until traction to the rear
wheel has been restored.
for
riding
the
prevailing
conditions.
disabled
may,
if
road
surfaces.
If
65
Advertisement
Chapters
Table of Contents
