Table of Contents
Advertisement
QUICK START Position
The QUICK START position operates the
electric starter allowing for a quicker
ignition start.
From the ignition off, press and hold the
engine
start/stop
QUICKSTART position with all the correct
conditions met, to start the motorcycle.
For more information, see page 144.
RUN Position
The engine start/stop switch must be in
the RUN position for the motorcycle to
operate.
STOP Position
The STOP position stops the engine.
Note:
•
Although the engine stop position
stops the engine, it does not turn
off all the electrical circuits and
may cause difficulty in restarting
the engine due to a discharged
battery.
Power ON/OFF Position
The Power ON/OFF position switches
the
electrical
instrument display between on or off.
This allows access to the instrument
display without starting the engine
when switched ON.
switch
in
circuits
and
General Information
Do not leave the switch in the Power
ON position for a long period of time as
this may cause damage to electrical
the
components and will discharge the
battery.
Hazard Warning Lights Button
To turn the hazard warning lights on or
off, press and release the hazard
warning light button.
The ignition must be switched on for the
hazard warnings lights to be activated,
but the hazard lights will remain active
if the ignition is switched off until the
hazard warning light button is pressed
again.
Steering Lock Button
To
lock
handlebar fully to the left and press the
steering lock button.
When the ignition is off then the engine
immobilizer is on. The engine immobilizer
is turned off when the ignition is started.
the
For reasons of security and safety,
always make sure the steering lock is
on
when
unattended.
Any
unauthorized
motorcycle may cause injury to the
rider, other road users and pedestrians
and may also cause damage to the
motorcycle.
Caution
the
motorcycle,
Warning
leaving
the
use
turn
the
motorcycle
of
the
95
Advertisement
Table of Contents
