Shuttle Timeout; Slow Paper Slew - Printronix P7000 User Manual

Chapter 4
ADVANCED USER
In a non-CT system, changing characters sets in LP+ causes the
active IGP to change to the same character set if the selected set
exists in IGP. If the active IGP has no access to the selected set, no
changes are made. Selecting a new character set in the active IGP
causes the LP+ to change to the same character set if the selected
character set exists in the active LP+ protocol. Not all sets are
shared between emulations in the Standard group of character
sets. As a result, selecting a set in the Standard group of LP+ or
IGP emulation may or may not cause the other emulation to have
the same set.
NOTE: The front panel option, Set Sharing, has no effect on the

Shuttle Timeout

The amount of time the shuttle continues moving after no data is
received. If your host is slow, setting the number to a higher value
will prevent the printer from spending time shuttling up and down
between data bursts.

Slow Paper Slew

•
Disable (default). The paper will slew and stack paper at
maximum speed.
•
Enable. Causes the paper to stack at a slower rate. This
ensures that certain forms will stack neatly.
Alarm
•
On (default). An audible alarm sounds (3 beeps) when a fault
occurs, such as a paper jam.
•
Cont. Beep. A continuous audible alarm sounds when a fault
occurs, which can be stopped by pressing CLEAR.
•
Off. No audible alarm will sound.
286
LP+ and CT/LP+ builds. The option only applies to the
builds with IGP.
This option is not available in the PCL-II or LG emulation.