Format Control - Printronix P7000 User Manual

Chapter 4
Coax/Twinax (CTHI) Emulation

Format Control

Enables the printer to reflect the same spacing as CTPC model
printers after absolute and relative move commands are executed.
•
Disable (default). Reflects distance, generated by the IGP/VGL
feature, IGP/PGL feature, and Hex Transparent control code
sequence, in the new position (after absolute and relative move
commands are executed).
•
Enable. Does not reflect distance, generated by the IGP/VGL
feature, IGP/PGL feature, and Hex Transparent control code
sequence, in the new position (after absolute and relative move
commands are executed).
Max. Print Width
Set the maximum print width at either 13.2 inches or the maximum
width of the printer. The default is 13.2 inches.
Buffer Print
•
Disable (default). The printer will print normally.
•
Enable. The printer prints the EBCDIC data and control codes
received from the host as hex values. Refer to page 315 for
information on how to obtain a hex code printout.
NOTE: Use of this parameter may alter print attributes set by the
186
host computer. A power cycle may be required after
changing Buffer Print from enable to disable.